Perun V3 Hybrid processor (universal wiring) - Perun

Adaptive trigger control   allows you to switch from a very short trigger pull to a long one, even in the field, with almost any trigger, including the standard one. Works without any modifications on most Tokyo Marui standard V3 gearboxes. See the manual for details and exceptions. Features: Adjustable trigger sensitivity Independently programmable firing modes Active brake with adjustable braking power Pre-cocking (with spring release function) Binary trigger 2-stage trigger Adjustable rate of fire DMR mode Low battery alarm Programming supported by multicolor LED DSG mode Diagnostic system Electronic   resettable fuse Function description: Adjustable trigger sensitivity - The trigger can be set to 5 sensitivity levels, from a very short pull required to fire a shot to a very long one. No trigger adjustment is necessary, and the trigger sensitivity can be changed even in the field. Independently programmed firing modes - Program the firing modes as you like by setting the safety, single shot, burst, or automatic modes in all selector positions. Active brake - The active brake stops the motor after each shot to prevent spring compression or, in the case of replicas with high firing rates, over-rotation (double shot problem). Pre-cocking - Fast trigger response can be a matter of victory or defeat, especially in CQB situations. With pre-cocking activated, the piston remains in the rear position after each shot with the spring already compressed, ensuring that the next shot is fired immediately after the trigger is pulled. To release the spring, press and hold the trigger for 2 seconds, then a second shot will be fired, this time without pre-tension and fully braked. Two-stage trigger   - a light pull of the trigger will result in a single shot or burst, while a deeper pull will result in a burst or fully automatic fire. The following modes are available: semi-burst, semi-auto, and burst-auto. Binary trigger   - Allows for easy double shots in semi-automatic mode. When this mode is activated and semi-automatic is set, shots will be fired not only when the trigger is pressed, but also when it is released. Fire rate reduction   - Reduce the rate of fire to save ammunition or make shooting from a replica more realistic. DMR mode - Represents the intervals between semi-automatic shots to comply with DMR rules in some fields. Low Battery Alarm   - Designed for Li-Po and Li-Ion batteries. If the battery voltage drops to a dangerously low level, the user will be alerted by short beeps that repeat every minute. This can also be freely turned on and off. DSG - Double Gear Detection mode specially designed to work with two-sector gearboxes. Diagnostic system - Continuously monitors the replica and the MOSFET itself. In case of any problems, it will immediately notify you of what it could be, which will greatly facilitate troubleshooting. Electronic fuse   - Protects your replica and battery in the event of a serious malfunction. Automatically disconnects the battery when a short circuit or blocked motor is detected. All settings are programmed exclusively using quick and easy-to-remember sequences of fire selector switches and trigger presses, supported by audible signals and a multi-color LED. This allows you to change settings at any time, in a matter of seconds, even under enemy fire. All settings are set separately for each selector position, so you can program the MOSFET exactly as you want. The Perun V2 Hybrid works seamlessly with any battery from 7V to 17V. It can also be used with most extreme setups.