Active brake V2 for stock - JeffTron

SPECIFICATIONS: - Built-in MOSFET with active brake on switching contacts from SHS - Easy installation inside the v.2 gearbox - Complete cabling allows for quick and easy installation in the weapon, long enough for all types of weapons with a battery in the rear - Power wires have a cross-section of 1.5 mm² (AWG16) with thin and rigid Teflon insulation, blue wire with a cross-section of 0.34 mm² (AWG22) with Teflon insulation - The length of the wires between the end of the gearbox and the connector is 290 mm - The electronics board is coated with a varnish that protects against water ingress into the device - If you want to use your own wires, choose the variant without cabling - If you need a different type of cabling, choose the variant with universal cabling - Designed for springs up to m160 - Designed for all types of commonly used batteries up to 17 V (Ni-xx 8.4 - 12V, lipol 7.4 - 14.8V) - The trigger contacts do not burn out - After the contacts are opened, the excess energy of the motor is used to stop it. The braking effect is strongest with a load motor with neodymium magnets. - No current is drawn in idle state - Due to the principle of operation of the AEG weapon mechanism, the piston stops in a random position in AUTO mode - For this device to function properly, the gearbox must have a functional interrupter, switch slide, reverse latch, trigger, and trigger stop (secured), i.e., as in a standard gearbox PRODUCT MANUAL:  download  here  [PDF, 771.12 kB] PACKAGING: - MOSFET with active brake on switching contacts with powered wires, DeanT connector and faston sleeves on wires - Trigger float - Screw for attaching to the gearbox - Installation manual WARNING:  Installation of this device requires a professional who knows how to solder and disassemble an AEG weapon. Never use a transformer soldering iron! Despite our best efforts, we cannot guarantee 100% compatibility of the device with all version 2 gearboxes. For most commonly available and widely used brands, the Mosfet - V2 can be installed without major modifications.